2
Features:
• Bullet drop compensator with interchangeable cams (except 5x33L)
• Mounting rings included (except 5x33 series)
• Illuminated Reticle with an 12 position rheostat
• Step Range Finder
• 1/8 MOA at 100 Yards
• All glass multi-coated optics
• Extra large objective lenses
• Prosheild and Everlight Lens coatings
• Sunshade
* ATN reserves the right to change the above specifications at any time without notice
OPeratING:
Battery INstallatION:
Install the battery into the housing with the polarity order as shown on
the battery housing cap. Battery Type: 3 Volt Lithium standard watch
battery type CR2032
(Fig.1)
.
MOuNtING:
Riflescopes can be mounted utilizing 30mm mounting rings. ATN mount-
ing rings allow to change the position of the riflescope on the weapon in
relation to a shooter by 1/3 of inch. Thus obtained, such positions are
additional to the already available fixed positions on the weaver rail.
For this purpose in the base of a mounting ring there is a rail with a fixing projection.
In case you need to change the position of the riflescope additionally please follow the steps mentioned
below for both rings
(Fig.2)
:
1. Loosen the two screws attaching the rail to the ring.
2. Take the rail out of the groove.
NOTE: If the rail is not taken out easily screw up one of the screws into the
threaded aperture at the middle of the rail until it stops. Then carefully con-
tinue rotating of the screw until it pushes out a rail from a groove.
3. About-face the rail.
4. Put the rail into the groove.
5. Fix the rail with the two screws.
For mounting the riflescope on the weaver rail:
1. Loosen the fixing screws on the sides of the mounting rings.
2. Place the riflescope on the weaver rail so that the projection of the rail, which is in the base of the ring,
enters the recess in the rail.
3. Tighten the fixing screws of the mounting rings.
CAUTION: Be sure gun is not loaded. Use safe gun handling procedures all the time.
FOcusING:
While holding the scope about four inches from your eye, quickly glance through the eyepiece at a
featureless, flatly lit bright area such as a wall or the sky.
CAUTION: Viewing the sun can cause serious eye injury, never look at the
sun with this product or even the naked eye.
If the reticle is not visible sharply turn the eyepiece (either direction) a
few turns
(Fig.3)
.
Quickly glance through the scope again. If the focus has improved, but
is still not perfect, continue focusing. If the focus condition become
worse turn the focus opposite direction.
NOTE: Unlike other sights, 12-36x80 has additional system for focusing
when shooting at small distance (Fig.4).
Figure 2
Fixing projection
Threaded aperture
Rail
Figure 3
Battery housing cap
Figure 1
