User Guide & General Maintenance
Rainier Summit R1
7
1-888-MY-AIR11 CAG-06-21-002 AtmosAir.com
Unit Settings
continued
If during initial adjustment you notice a “sweet” or “metallic” presence in the air, this may be caused by the Ion Control being set too
high or the Fan Speed set too low and too many ions for the space the unit is applied to. Adjust the Ion Control down and the Fan
Speed up to balance the ions. Over ionizing is not optimally effective for air cleaning.
Room Conditions
The conditions of a space, dust levels, odors, chemicals and other contaminants will have an effect on the square footage capacity of
the unit. As more odors are present or dusty conditions occur, more ions are needed to achieve good air cleaning and will reduce the
effective area the unit can treat. Also in dusty conditions or heavy chemical contaminant conditions the system filter may need to be
replaced more frequently. Maintenance and filter replacement will be covered on the following page.
Care and Handling
With some basic care and precaution your Rainier R1/R2 should give you years of trouble free use. Please follow all of the
recommended maintenance steps which are detailed on the following page. These are intended to keep your Rainier operating at top
performance and trouble free.
Failure to follow the recommended maintenance intervals may result in premature wear of the
unit and system failure which will not be covered by manufacturer’s warranty.
While the unit is made of sturdy construction, please do not drop the unit as damage may occur. Placing the unit in wet
conditions, areas of condensing moisture, or in areas of high relative humidity (70% or above) can cause premature wear and
malfunction. Please avoid these areas. Excessive heat can also cause premature wear and malfunction. Avoid areas where
temperatures will exceed 100 degrees F or 38 degrees C.
Maintaining Your Unit
The Rainier R1/R2 will require maintenance at certain intervals to ensure optimal performance and protection against premature wear.
There are 2 main components that will need periodic replacement, the system filter and the bi-polar ion tube.
The system filter is intended to capture dust and dirt and chemical contaminants. The R1/R2 is equipped with a high efficiency
pleated filter to help filter out dust and particles which is impregnated with carbon to help capture gasses and odors.
Warning—Before attempting any service to the unit be sure the unit is switched off and power plug is disconnected!
To replacethe filter, simply remove the filter which is located at the rear of the unit, by first pulling upward and then outward and
replace with the new filter.
Continue on Next page
