Atmel ATA8510-EK1, Примечание к применению

Страница: 9 / 22

3. Hardware Description
The description and documentation of the Xplained PRO SAMD20 board and the Xplained PRO OLED1
board are available within Atmel
®
Studio 6 or 7 on the Atmel website [4]. The hardware description of the
Xplained PRO ATA8510/15 extension board and the remote sensor are included in the tool pack zip folder
[10]. The base station is powered by the USB cable whereas the remote sensor uses a CR2032 coin cell
battery.
3.1. Base Station Transceiver
The Atmel
®
ATA8515 base station transceiver is mounted on an adapter board as shown in Figure 3-1 .
This adapter board is plugged onto the Xplained PRO ATA8510/15 extension board which includes the
LEDs 1-4. The adapter board has a programming adapter XISP1 which is used for programming the
EEPROM configuration data into the device. This extension board is connected to the EXT1 and PWR
header of the Xplained PRO SAMD20 board. The extension board has two additional connectors, X6 for
supplying the kit with 5V and X7 to access the kit’s internal 3V supply voltage.
Figure 3-1. Base Station Transceiver Board
The connector pins of the Xplained Pro ATA8510/15 extension board are summarized in the following
tables
Table 3-1 , Table 3-2 , Table 3-3 and Table 3-4 .
Table 3-1. Connector X3
Function Pin Pin Function
ID_data 1 2 GND
-- 3 4 --
NPWRON1 (PB06) 5 6 NRESET (PB07)
LED3 (PB02) 7 8 LED4 (PB03)
EVENT (PB04) 9 10 --
-- 11 12 --
Atmel User Guide for the Evaluation Kit ATA8510-EK1 [APPLICATION NOTE]
Atmel-9343D-ATAN0046_Application Note-09/2016
9