3-4
AT91SAM-ICE User Guide
6206B–ATARM–04-Mar-08
A right-click on the driver opens a context menu which contains the item “Properties”. If you select this
item, a new dialog is opened and should report: “This device is working properly”.
3.2
Debug Installation
The SAM-ICE RDI software is an RDI interface for SAM-ICE. It makes it possible to use SAM-ICE with
any RDI compliant debugger.
The main part of the software is an RDI compliant DLL, which needs to be selected in the debugger.
Supported configurations are described on the AT91 DVD-ROM. For additional information on debug,
refer to the SAM-ICE "Getting started" bar menu.
3.3
Connecting the Target System
3.3.1
Power-on Sequence
SAM-ICE must be powered on before connecting it to the target device. First, connect SAM-ICE to the
host system via the USB and then connect SAM-ICE to the target device via JTAG. Power-on the device
after you have connected SAM-ICE to it.
3.3.2
Verifying Target Device Connection
If the USB driver is working properly and your SAM-ICE is connected to the host system, you may con-
nect SAM-ICE to your target hardware. Then start
JLink.exe
again; it should now display the same
SAM-ICE related information as above. In addition, it should report that it found a JTAG target and the
target core ID. The screenshot below shows the output of JLink.exe. As can be seen, it reports a SAM-
ICE with one JTAG device connected.
3.4
Problems
For help with any of the steps described above, refer to
for troubleshooting tips.
