AT91CAP9-STK Starter Kit User Guide
1-1
6351B–CAP–27-Jun-08
Section 1
Introduction
1.1
Purpose
This document is a presentation of the hardware associated with the AT91CAP9-STK
®
Starter Kit.
This product is derived from the Atmel AT91CAP9-MZ and AT91CAP9-MB demonstration boards.
1.2
CAP
™
Starter Kit Board
The AT91CAP9-STK Starter Kit is built on a single PCB, including:
AT91CAP9S ARM926EJ-S
™
-based microcontroller system-on-chip
64M Bytes of SDRAM application memory
512M Bytes of NAND Flash
DataFlash
®
with up to 8M Bytes
External interfaces for:
– 10/100 Base-T Ethernet
– USB Host and Full Speed/High Speed Device
– ¼ VGA LCD Panel with Touch Screen
– SD Card
– 4 analog inputs
– audio headphones
Altera
®
Stratix
®
2 EP2S15F484 FPGA and its associated EPCS16 serial configuration memory. The
FPGA provides 15600 four-input Lookup Table (LUT) equivalents, corresponding to approximately
124800 gates in the CAP MP Block.
64 general-purpose I/O connections from the AT91CAP9S, and 2 banks of 64 I/Os from the FPGA, for
application-specific external interfaces
CE-JTAG interface for CAP9 JTAG programming, and a USB-Blaster-JTAG interface for Stratix2 JTAG
programming. These facilitate system debug.
Atmel's AT73C224 and AT73C239 ICs for power supply and battery management.
Atmel’s AT73C213 for audio DAC
Atmel’s AT73C205 for battery charger