25570 Rye Canyon Rd. Valencia, California 91355
(661) 294-7999 voice (661) 294-1115 fax
www.activethermal.com
If exhausting through the top panel
, remove the front panel of the
Cool-stack II and, using
adhesive tape, fasten the sheet
of black plastic film to the inside
of the front panel at each end,
blocking the vent openings as
shown in figure 1. Remove the
metal blank-out panel from the
top of the Cool-stack II and
replace it with the large exhaust port as shown in figure 2. (It can be
installed with the opening closer to the front panel or further away;
either way is acceptable.) Proceed to step 1 of the installation section.
If exhausting through the rear panel
, remove the Cool-stack II's front
and top panels (4 phillips screws on the rear panel), cover the inside of
the front panel as in figure 1, and remove the plastic sheets covering
the 2 rear panel exhaust openings. Replace the front and top covers
(note that the return bend at the rear of the cover fits
inside
the
chassis), and mount the 2 rear panel exhaust ports as shown in figure
3. (Four screws are provided in the accessories box.) Proceed to step
1 of the installation section.
Figure 1
Figure 2
