6
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
TCP/IP
For convenience, the UHD-SW comes with DHCP on. This enables the switcher to be connected
to a network without knowing available IP addresses. If your network does not allow dynamic IP
addresses or if you are using the UHD-SW with a TCP/IP control system, this feature may be turned
off and the IP address set using RS-232 commands or the webGUI.
TCP/IP WebGUI
Atlona has created an easy to use WebGUI for initial setup and later changes to the configuration
of the UHD-SW.
To begin, plug a LAN cable into the LAN port of the UHD-SW and your network, then type the IP
address of the UHD-SW into a web browser of a PC connected to the same network
(as seen below)
.
To find the switcher IP:
use RS-232 command “IPCFG”.
Important:
If any stability issues are experienced, disable any anti-virus or firewall that may interfere with
net work communication to the switcher. Once set up is done and the switcher GUI is no
longer used, the firewall and anti-virus can be re-enabled.
A login screen will appear
(this is the same log in for admin and general users)
. For the first log in
(and future
admin changes)
the username is “root” and password is “Atlona”.
Note:
Only the admin password can be changed (see page 9). The username will always remain “root”.
Note:
IP addresses may also be found using common free IP scanner software such as “Advanced IP Scanner”