3
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
To rack mount the UHD-H2H-88M unit: use the rack mount ears, the 4 screws from the sides of
the UHD-H2H-88M, and 4 rack screws.
To affix the rack mount ears, remove the two screws on each side of the UHD-H2H-88M and affix
the rack ears to the UHD-H2H-88M (as shown in the picture above).
Place the UHD-H2H-88M in the rack, lining the holes in the rack ears with the holes in the rack.
Once placed, use the rack screws to keep the unit in place. (as shown in the picture to the left).
Note:
Increase the air flow as needed to maintain the recommended temperature inside the rack.
Note:
Do not exceed maximum weight loads for the rack. Install heavier equipment in the lower part of the rack for
stability.
POWER
ENTER
CANCEL
INFO
EDID
FNC
1
2
3
4
5
6
7
8
POWER
ENTER
CANCEL
INFO
EDID
FNC
1
2
3
4
5
6
7
8
Rack Mounting
Category Cable and Connector
For the category cables used in the installation of these products, please be sure to use a 568B
termination as pictured below:
Important!
4K
(UHD)
signals are sensitive to cable quality and installation technique. It is recommended to
use CAT6a/7 solid core cables for best results.
Connector type and size is very important to ensure extenders work correctly. Please use the
matching cable type with the correct RJ45 connector.
(
e.g.
CAT 7 cable should use a CAT 7 connector)
