6
Installation Guide
AT-HDR-EX-70C-KIT
Mode 1: Link
This is the default position of the dial and puts the unit into normal operation.
Mode 2: FW
This mode sets the transmitter into firmware updating mode. View Firmware Updating
instructions on the next page for manual updating.
1. Open the Analyzer software.
2. Plug in the power supply of the transmitter.
3. Connect the receiver using an HDBaseT cable.
4. Connect an active source to the transmitter and an active display to the receiver. Set the
source to the highest resolution.
5. Set the Utility dial to
3
.
6. Connect the transmitter’s Utility mini USB port to a PC using a mini USB to USB A cable.
7. Select the COM port in the Analyzer software and press the connect button.
8. Once connected, press the
Start
button. The link information and cable pairing test
results will display. Follow the instructions on the Analyzer software for any pair failures.
9. When complete, set the utility dial back to
1
or
4
for normal operation.
Mode 3: TEST
This mode sets the transmitter into HDBaseT testing and debugging mode. Firmware may also
be updated in this mode using the Atlona Analyzer software.
DC 48V
-
+
RS-232
RX TX
S
S
HDBaseT OUT
HDMI IN
IR OUT
IR IN
AT-HDR-EX-70C-TX
POWER
LINK
TEST
UTILITY
1. LINK
2. FW
3. TEST
4. 5V LOCK
UTILITY
The utility port and dial are used for updating firmware,
HDBaseT cable testing/debugging, and 5V lock. Use the Dial
to switch between modes.
NOTE:
Before setting the unit to mode 3 (TEST), the Atlona Analyzer should be
downloaded from the resource tab located at
http://www.atlona.com/products/AT-HDR-EX-70C-KIT
Quality Testing
Firmware Updating
(Analyzer software only)
1.
Download the firmware file from the firmware tab located at
http://www.atlona.com/AT-
HDR-EX-70C-KIT
.
2. Set the dial to
3
.
3. Open the Analyzer software.
4. Connect the transmitter’s Utility mini USB port to a PC using a mini USB to USB A cable.
5. Select the COM port and press the connect button.
6. Select Update from the top navigation.
7. Press the
Browse
button and a new window will open.
8.
Select the firmware file for the transmitter and press open.
9. Press the
Load
button. The progress bar will display the update progress.
10. Once the update is complete, set the dial back to 1 or 4 to return to normal operation.
