4
Installation Guide
AT-HDR-EX-70C-KIT
4. Mount the unit using the oval-shaped holes, on each mounting bracket. If using a drywall
surface, a #6 drywall screw is recommended.
NOTE:
Mounting brackets can also be inverted
to mount the unit under a table or other flat
surface.
FW
AT-HDR-EX-70C-RX
POWER
LINK
1. Connect an HDR source to the
HDMI IN
port on the transmitter.
2. Connect an HDR display to the
HDMI OUT
port on the receiver.
3. Connect an HDBaseT cable, from the
HDBaseT OUT
port on the transmitter, to the
HDBaseT IN
port on the receiver.
4.
*Optional*
Connect a 3rd party controller to the transmitter using either the 3-pin RS-232
or the 2-pin IR IN ports.
5.
*Optional*
Connect an IR receiver to the IR IN port of the receiver.
6.
*Optional*
Connect an IR emitter to the IR OUT port of the transmitter or receiver.
7. Connect the included 48V power supply into the transmitter.
8. Connect power supply to an AC outlet.
Installation
Refer to the tables below for recommended cabling when using Altona products with HDBaseT.
The green bars indicate the signal quality when using each type of cable. Higher-quality signals
are represented by more bars.
Cable Recommendation Guidelines
Core
Shielding
CAT5e
CAT6
CAT6a
CAT7
Solid
UTP (unshielded)
N/A
STP (shielded)
Performance Rating (MHz)
350
500
600
800
*Atlona recommends TIA/EIA 568-B termination for optimal performance.
Cable*
Max. Distance @ 4K
Max. Distance @ 1080p
CAT5e / CAT6
115 feet (35 meters)
200 feet (60 meters)
CAT6a / CAT7
130 feet (40 meters)
230 feet (70 meters)
IMPORTANT:
Stranded or patch cables are not recommended due to performance
issues.
