www.atlona.com | toll free:
1-877-536-3976
For International: 1-
408-962-0515
6
7. ALL: Press this button to set all the outputs to display the same input. After, pressing the “All” button, press
an input number and press enter to confirm the selection.
8. MEMORY: Press this button to set your desired preset (total of 6 presets). Press the desired setting num-
ber first. When all the inputs/outputs are being set, press MEMORY to record into the system.
*there are 6 settings can record into the system.
Factory default setting is 1.12345678, 2.87654321,
3.11223344, 4.55667788, 5.11221122, 6.33443344.
9. RECALL: Press this button to recall the previous preset from the memory total of 6 presets, and select from
1~6 for the desire setting. Press the enter button to confirm the selection.
10.
OUT
A to H &
IN
1 to 8: Press the output source selection to correspond to the inputs. First press your
output selection from A to H and wait for 2 sec. Then press the input selection again from 1 to 8 then press the
enter button to confirm your setting. Each output selection only allows a single input setting each time.
7.1.1. Troubleshooting:
1. No Video Signal – please try learning EDID see. Page 4 sec. 4
2. No Video on one of the TV’s: Most likely one of the TV’s has a lower resolution capability than others. The
switcher has no ability to scale one output to a lower resolution, therefore the lower resolution settings would
have to be forced on the source. Please switch your DVD Player or another source to the lowest displays op-
timal resolution. If you don’t want to sacrifice the quality on all the TV’s, Atlona offers HDMI Down Converter to
convert the signal from (example: 1080p 720P)
3. Audio Receiver only shows Stereo or PCM – Most of TV’s are only able to handle Stereo or PCM though
HDMI, therefore if you had learned EDID of the TV, than that EDID mode is being used to send signal to AV
Receiver. You can learn EDID of the receiver (see page 4 sec. 4); however if TV is not able to understand Digi-
tal Audio it might “Mute” or output distorted audio.
4. No Signal on any of the TV’s: Make sure the Input/Output cables are working by connecting them to the
sources and displays directly, bypassing the switcher
5. Not All of my sources are HDMI: The solution to it is to contact Atlona for a conversion box to convert any
signal you might have to HDMI. Atlona offers a wide variety of conversion boxes specifically designed for ap
-
plication such as this.
