Installation
2
3
1 EDID Control Switcher: Default factory setting is TV, leave as it is when the displays are work
-
ing properly. Switch to STD to use build-in EDID Detail capability in Note.
2 RS-232 communication port: Connect the COM port of your PC for the distant control over RS-
232 channel. Detail specification in section 9.
3 HDMI outputs: Connect each of these output ports to the HDMI display(s).
4 HDMI inputs: Connect input ports to the HDMI or DVI output of your source equipment such as
DVD player or set-top-box.
5 Power: Plug the 5VDC power supply into the unit and connect the adaptor to AC wall outlet.
6 IR extender.
Note:
1. EDID Control Switch: STD(INT) and TV(EXT), Default setting is TV
2. When EDID is on TV: Leave as it is if display is proper, unit will detect the first HDMI output
source’s EDID and record in the unit. If the first detected output source is DVI, it will pass to
next source until the first HDMI been detected. The detection priority is HDMI v1.3 > HDMI
v1.2 > DVI.
3. When EDID is on STD: unit use build-in EDID Video Support->1080p 12bit(max) Audio Sup
-
port->PCM2
4. Your EDID selection will only activate when the unit is replugged and powered on.
1
3
4
5 6
2
