Atlas TC289, Руководство по установке и эксплуатации

Страница: 19 / 32

REV. 01
15 / 27
4.4.1 GT version
Do NOT LEAN on the turntable during this operation. Possibly dirty dust on
turntable could offend the operator’s eyes. For the same reason, be carefully as
not to accidentally push the inflating pedal while working
.
x
When the pedal located on the left side of the machine
body is pushed down to its intermediate position (B),
air is released from the airline gauge.
x
When the pedal (C) is pushed down completely, air is
released from the airline gauge with a powerful jet from
the nozzles located on the turntable clamps.
4.5 TURNTABLE LOCKING VALUE ADJUSTING
The tire changer turntable is preset by the manufacturer on a middle range measure from11” to 23”
ext. (considering the rim outer side and) from 13” – 25” int. (if you lock the rim from inner side).
It is however possible to change this dimension range in case of need when working on larger or
small rims; it is enough to change the position of the 4 clamps are shown in the figures below.
The obtainable value starts from a minimum of 10”-22” ext. and 12”-24” int. until a maximum of 12”-
24” ext. and 14”-26” int.
To change the position, proceed as follows:
x
Unscrew screw (1) by means of the Allen wrench.
x
Remove the locking clamp (2) and the slide piece (3).
x
Align the slide hole with one of the guide holes (4) according to the locking dimensions you
want to set. Use the measures below for reference.
It is important to perform the above mentioned operation for all the 4 clamps to
avoid any unbalance in locking phase.
Fig. 13