27
VI. OPERATION INSTRUCTIONS
Please read the safety tips carefully before operating the lift
To lift vehicle
1.
Keep clean of site near the lift;
2.
Position lift arms to the lowest position;
3.
To shortest lift arms;
4.
Open lift arms;
5.
Position vehicle between columns;
6.
Move arms to the vehicle’s lifting point;
Note:
The four lift arms must at the same time contact the vehicle’s lifting point
s
where manufacturers recommended
7.
Push but
ton “
UP”
until the lift pads contact underside of vehicle totally. Recheck to
make sure vehicle is secure;
8.
Continue to raise the lift slowly to the desired working height, ensuring the balance
of vehicle;
9.
Push lowering handle to lower lift onto the nearest safety. The vehicle is ready to
repair.
To lower vehicle
1.
Be sure clear of around and under the lift, only leaving operator in lift area;
2.
Push
button “
UP”
to raise the vehicle slightly, and then release the safety device,
lower vehicle by pushing lowering handle.
3.
Open the arms and position them to the shortest length;
4.
Drive away the vehicle.
5.
Turn off the power.
Содержание BP10000X
