16
2. Lower the carriages down to the lowest position, then use the
8#
socket head wrench
to loosen the socket bolt
(See Fig. 23)
3. Adjust the moon gear as arrow direction
(See Fig. 24).
4. Adjust the moon gear and arm lock to make it to be meshed, then tighten bolts of
arm lock
(See Fig. 25).
N. Add Hydraulic Fluid to Power Unit
To assure correct operation and to add to the longevity of all hydraulic parts use a high
quality AW32 or AW46 anti-wear hydraulic oil.
O. Install Electrical System
Connect a power source matching the requirement of the Power Unit.
Note: 1. Install the limit switch
2. For the safety of operators, the ground wire must be used.
Single phase motor
(See Fig. 26).
1.
Connecting the two power supply lines (active wire
L
and neutral wire
N
) to
terminals of AC contactor marked L1, L2 respectively.
2.
Connecting the two motor wires to terminals of AC contactor marked
T1, T2
.
3.
Connecting
A2
to
L2
of AC contactor.
4.
Terminal
4#
of control button is connected with terminals
A1
of AC contactor;
Fig. 24
Adjust moon gear
Locking the bolts after
the moon gear and
arm lock engaged well
Fig. 25
Содержание BP10000X
