11
Figure 21
Figure 22
12. OPERATING YOUR
FAN
Speed settings for warm or cool weather depend on
factors such as the room size. Ceiling height,
number of fans and so on.
NOTE: To operate the reverse function on this fan,
press the reverse button while the fan is running.
Warm weather - (Forward) A downward airflow
creates a cooling effect as shown in Fig. 21. This
allows you to set your air conditioner on a warmer
setting without affecting your comfort.
Cool weather - (Reverse) An upward airflow moves
warm air off the ceiling area as shown in Fig. 22.
This allows you to set your heating unit on a cooler
setting without affecting your comfort.
NOTE:
If the self calibration test failed, turn the AC
power off; restore power and process the self
calibration test again.
NOTE:
During self calibration test, the remote and
the wall control are non-functional.
NOTE:
The learning frequency function and self
calibration test will continue to retain the last set
frequency and calibration set even when the AC
power is shut off. If the frequency is changed the
self calibration test will occur again.
F. “D” and “ON” dip switch:
The “ON” selection is the light dimmable selection and is
to be used with all bulbs except for CFL bulbs. The “D”
selection is the light ON only (no dimming function) and
is to be used with CFL bulbs as CFL bulbs in most cases
cannot be used with dimming controllers.
This receiver provides the following protective
function:
1. Lock Rotor Position: The DC motor has a built-in
safety against a stalled or locked rotor condition
(stalled blade rotation). If there is an obstruction or
fault with the motor, the current monitoring function
will automatically turn power off to the motor after 30
seconds. Remove the obstruction and turn the AC
power off. Restore power and re-start fan motor.
2. Over 80W protection: When the receiver detects
motor power consumption which is greater than
80W, the receiver power will be stopped and
operation will immediately discontinue. Wait for 5
seconds and then turn the receiver power back on.
