10
Figure 20
Figure 18
Figure 19
ON ECE
1 2 3 4
ON
D
ON ECE
ON
D
Restore power to ceiling fan and test for proper
operation.
A. I, II, III, IV, V and VI button:
These six buttons are used to set the fan speed as
follows:
I = minimum speed
II = low speed
III = medium low speed
IV = medium speed
V = medium high speed
VI = high speed
B. button:
This button turns the fan off.
C. Reverse button:
This button is to control fan direction
D. Light button
This button is to control light. Switch the “D” and “ON”
dip switch on the back of transmitter to decide the light
in “ON/OFF” or “Dimmable” condition.
E. SET code setting button:
Your DC brushless motor is equipped with automatically
learned type remote control and a wall control. If two
fans or more in a house, it is recommended that you not
use the factory code settings. Change codes setting to
any other combination of dip switch setting to avoid fan
interference issues, but users need to do control setting
process as below once the code setting is changed.
Please refer the "D" "SET" code setting button section.
Follow the below steps to set the remote control:
The auto learning function will only mandate within 60
seconds when turning the fan’s AC power ON.
a) Select desired frequency from the transmitter.
b) From the wall or remote transmitter, press the “SET”
button, and hold the “SET” button for over 10 seconds.
Once the receiver has detected the frequency, the light
will flash twice, and the fan will automatically begin to
operate and start to rotate in the counterclockwise
direction and on the highest RPM for 3 minutes. When
counter clockwise rotation has finished, the fan will
automatically reverse to clockwise direction again to the
highest RPM for 3 minutes. Fan will shut off when the
self calibration test has finished. The total self calibration
test will last about 6 minutes.
11. PROGRAMMING YOUR
FAN AND OPERATING
THE REMOTE CONTROL
AND WALL CONTROL
Before programming takes place, fan must be fully
assembled and mounted to the ceiling with blades
attached.
You must also choose which control you
will be using for programming the fan, the remote
or the wall control. No other wall control should be
used with this fan but that which was included.
Using another wall control other than ours will
damage your fan and void your warranty.
Install one 23A/12V battery (included). To prevent
damage to transmitter, remove the battery if not used
for long periods of time (Fig. 18 & 19)
