7. PROGRAMMING YOUR
FAN AND OPERATING THE
REMOTE CONTROL
Figure 15
Figure 16
Your DC brushless motor is equipped with an automatically learned type
remote control.
Install one 23A/12V battery (included). To prevent damage to the transmitter.
Remove the battery if not used for long periods of time. (Fig.15)
Restore power to the ceiling fan and test for proper operation.
A. SET code setting button:
Follow the steps below to use the SET button:
a) With the fan’s power off, arrange code switches to the desired setting. If
installing only one fan, the factory setting is usually acceptable.
b) After installing the unit and restoring power to the fan, press and hold the
“SET” button 1-5 seconds. You must press the “SET” button within 60
seconds of restoring power to the fan.
c) The fan will start to run and begin the control setting process. The
fan will run in both directions for a total of approximately 5 minutes.
d) When the fan stops after approximately 5 minutes, the control and speed
setting process is complete and the fan is ready for use.
IMPORTANT NOTE:
If installing multiple fans in one location, ensure each
fan has its own unique setting. Also ensure there is only power going to the
fan being set, and power to any other fan must be turned off during initial
programming set up.
The receiver provides the following protective function:
1. Lock position: The DC motor has a built-in safety against obstruction
during operation. If there is an obstruction, the motor will stop and then the
power will automatically go off in 30 seconds. Remove the obstruction and
reset.
2. Over 80W protection: When the receiver detects motor power
consumption which is greater than 80W, the receiver’s power will be stopped
and operation will immediately discontinue. Wait for 5 seconds and then turn
the receiver power back on.
B. I, II, III, IV, V and VI button
:
These six buttons are used to set the fan speed as follows:
I = minimum speed
II = low speed
III = medium low speed
IV = medium speed
V = medium high speed
VI = high speed
C.
Button:
This button turns the fan off.
D.
Reverse button:
This button is to control fan direction
6
Содержание Irene YG432-MG
Страница 1: ...YG432 MG FAN RATING AC 220 240v 50Hz...
