5
Figure 9
Registration
slot
Screw
Safety cable
Figure 8
4. Loosen the two set screws and remove the
hitch pin and lock pin from the central
shaft/top coupling of the motor assembly.
Doing so will allow the down rod to enter the
central shaft. (Fig. 8)
5. Route wires exiting from the top of the fan
motor through the coupling cover, canopy
cover and canopy and then through the
ball/downrod. (Fig. 8)
6. Align the holes at the bottom of the downrod
with the holes in the collar on top of the
motor housing. Carefully insert the hitch pin
through the holes in the collar and downrod.
Be careful not to jam the pin against the
wiring inside the downrod. Insert the lock pin
through the hole near the end of the hitch pin
until it snaps into its locked position. (Fig. 8)
Warning/Caution:
Failure to properly install
lock pin as noted in step 6 could result in fan
loosening and possibly falling.
7. Tighten two set screws on top of the fan
motor firmly.
8. Now lift the motor assembly into position and
place the hanger ball into the hanger bracket.
Rotate down rod until the "Check Tab" has
dropped into the "Registration Slot" and the
down rod and ball assembly seat firmly. The
down rod and ball assembly should not rotate
if this is done correctly. (Fig. 9)
9. An additional safety support is provided to
prevent the fan from falling. Secure the safety
cable to the ceiling joist with screw and
washer. (Fig. 9)
Supply wires
Downrod
Coupling cover
Canopy
Canopy cover
Set screws
Hitch pin
Lock pin
