7
Figure 12
Outlet box
Hanger
bracket
Canopy
Canopy cover
Screws
4. If your outlet box has a GROUND wire
(Green or Bare Copper) connect this wire to
the Hanger Ball and Hanger Bracket Ground
wires. If your outlet box does not have a
Ground Wire, then connect the Hanger Ball
and Hanger Bracket Ground Wires together.
Secure wire connection with the plastic wire
nut provided. (Fig. 11)
5. Tuck connections neatly into ceiling outlet
box.
6. Slide the canopy up to hanger bracket and
place the key hole on the canopy over the
screw on the hanger bracket, turn canopy
until it locks in place at the narrow section of
the key holes. (Fig. 12)
7. Align the circular hole on canopy with the
remaining hole on the hanger bracket, secure
by tightening the two set screws. Note: Adjust
the canopy screws as necessary until the
canopy and canopy cover are snug.
Warning:
Make sure tab at bottom of hanger
bracket is properly seated in groove of
hanger ball before attaching canopy to
bracket. Failure to properly seat tab in groove
could cause damage to electrical wiring.
