Unpacking your new
401/601 Atlas Alignment Machine
Congratulations on the purchase of your new Atlas Alignment
Machine. This memo is provided to get you up and going in the
fastest possible manner.
1.
Your machine is ready to go out of the box. There is no need to install software, calibrate, or do
anything other than proceed with cable installation.
2.
Unscrew the four screws on the front panel of the machine and four screws on the back cover of the
machine. Note: the back cover will have a ground wire attached so be careful not to pull it lose when
you set this to the side.
3.
If you have a 601 model the only connections that will need to be made will be at the back of the
computer. You will plug in the usb cables, monitor cable (VGA) and power cable.
Blank CPU 601 Connected
