Atlas Copco U190 PACE KD WUX, Руководство по установке, Страница: 35 / 92

- 35 -
STARTING / STOPPING
BEFORE STARTING
1. Before initial start-up, prepare battery for
operation if not already done. See section
Recharging a battery .
2. With the compressor standing level, check the
level of the engine oil. Add oil, if necessary, up to
the upper mark on the dipstick. Also check the
engine coolant level. Consult the Engine
Operation Manual for the type of coolant and type
and viscosity grade of the engine oil.
3. Check the level of the compressor oil. The pointer
of oil level gauge (OLG) should register in the
green range. Add oil if necessary. See section
Engine oil for the oil to be used.
4. Check that the fuel tank contains sufficient fuel.
Top up, if necessary. Consult the Engine
Operation Manual for the type of fuel.
5. Drain any water and sediment from the fuel filters
until clean fuel flows from the drain cock. See
section Priming instructions .
6. Empty the dust trap of each air filter (AF). See
section Cleaning the dust trap .
7. Check coolant level in engine coolant top tank.
Top up, if necessary. Consult the Engine
Operation Manual for coolant specifications.
8. Attach the air line(s) to the closed air outlet
valve(s). Connect the safety chain.
Safety precautions
Make sure the fuel tank is filled up.
Before removing oil filler plug (FP),
ensure that pressure is released by
opening an air outlet valve.
No external force may be applied to the
air outlet valve(s), e.g. by pulling hoses
or by connecting equipment directly to
the valve(s).
Do not disconnect power supply to
control box in any way when the control
box is switched on.
When the compressor is put in operation
for the first time and after running out of
fuel or changing the fuel filter, follow the
specific start procedure as described in
section Priming instructions.