Atlas Copco QLT M10, Инструкция по эксплуатации

Страница: 39 / 46

- 39 -
Safety Precautions
• Not allowed on the shaft tube welding or drilling.
• Select the matching wheel hub: wheel offset, PCD
(bolt circle), tire bolt hole diameter, with the angle
must be connected with the hub and the wheel
bolts to match. Particular attention to the
recommended tightening torque Tightening wheel
bolts (nuts).
Maintenance
10,000 km or 3 years later:
• Check the wheel bearing axial clearance and
adjust if necessary.
• Check the quality and quantity of grease and
replace if necessary.
Operation
Check the axle wheel bearing axial clearance:
Steps:
• Jacking trailer, check whether the wheels turn
smoothly, without hindrance.
• Axial flipping tires, whether we can feel the
obvious gap
Re-adjust the axle hub bearing axial
clearance:
Steps:
• Remove the wheels and wheel covers.
• Remove the slotted nut cotter pin.
• Tighten shaft nut, then back to loose 1/2 turn (180
°), then tighten 1/4 turn (90 °).
• Check the wheel functioning - is free to rotate, and
the wheel can not be detected with axial clearance.
• Plug cotter pin.
Note: The bearing clearance adjustment too tight
can cause bearing damage.
• check the quality and quantity of grease, if
necessary, the filling or replacement of grease.
Wheel Bearing Grease: 2 # of lithium grease.
• Replace the wheel hub cover.
Wheel bolt tightening torque
U-bolt nut tightening torque
Thread
Size
Hexagon
square
width
Tightening torque
Nm
M12X1.5 SW19 90
Thread
Size
Hexagon
square
width
Tightening torque
Nm
M12X1.5 SW18 90