Atlas Copco QAS 150-200 Cud, Инструкция по эксплуатации

Страница: 40 / 82

- 40 -
Stopping Qc1002™
To stop the unit locally, proceed as
follows:
– Switch off the load.
– Switch off circuit breaker Q1.
– Let the engine run for about 5 minutes.
– Stop the engine by putting the starter switch S20
in position O.
– Lock the side doors and the door of the indicators
and control panel to avoid unauthorized access.
To stop the unit when the starter
switch is in position
, proceed as
follows:
– Switch off the load.
– Stop the engine by putting the remote start/stop
switch in position stop or by putting the starter
switch S20 in position O.
– Cooldown period default 15 sec.
– Lock the side doors and the door of the indicators
and control panel to avoid unauthorized access.
Operating Qc2002™
Starting Qc2002™
To start up the unit locally, proceed
as follows:
– Switch on the battery switch.
– Switch off circuit breaker Q1. This is not
necessary when a plant contactor is installed
between Q1 and the load.
– Put the starter switch S20 in position I (ON).
Voltage is applied to the Qc2002™ module.
– The unit can be started manually by pressing the
START button on the Qc2002™ module.
– The unit starts a preheating cycle which takes 12
seconds.
– After the preheating period, the unit will start. The
starting attempt will take maximum 12 seconds.
– Switch on circuit breaker Q1 in case no contactor
is installed.
To start up the unit from a remote
location, proceed as follows:
– Put the starter switch S20 in position I (ON).
Voltage is applied to the Qc2002™ module.
– Switch on circuit breaker Q1.
– For remote start:
• Put the unit in Island mode. Push the
AUTOMATIC button. Use an external switch
to start the machine.
or
• Put the unit in AMF mode. Push the
AUTOMATIC button. The machine will start
automatically when Mains fails.
– The unit starts a preheating cycle which takes 12
seconds.
– After the preheating period, the unit will start. The
starting attempt will take maximum 12 seconds.