LTV39-2 R56-HAD
EN
Service
© Atlas Copco Industrial Technique AB - 9839 2906 01
13
Cleaning
Clean all parts thoroughly in white spirit or similar cleaning agent. To prevent clogging and decreased
power, it could be necessary to clean the strainer (if used) and the exhaust filter between the overhauls.
Inspection
After the cleaning, inspect all parts. Damaged and worn parts should be replaced.
Tightening of Threaded Connections
The tightening torques indicated in the exploded views list in ServAid (see Spare parts section in
) are established to achieve the correct clamping force and prevent the parts from
coming loose.
When servicing these parts, they must be able to open up without being destroyed. In special circum-
stances (depending on application and usage) the parts may however come loose after some time of op-
eration. In such cases the torque can be increased by 10-20%. If necessary, a low or medium threadlock-
ing fluid can also be applied.
Example
Lubrication Instructions
Rust Protection and Cleaning
Water in the compressed air can cause rust. To prevent rust we strongly recommend to install an air dryer.
Water and particles can cause sticking of vanes and valves. This can be prevented by installing an air fil-
ter close to the product to avoid pressure drop.
Before longer stand stills always protect your tool by adding a few drops of oil into the air inlet. Run the
tool for 5–10 seconds and absorb any access oil at the air outlet in a cloth.
Lubrication Guide
Brand
General purpose, Bearings and Gears*
BP
Energrease LS-EP2
Castrol
OBEEn UF 1
Esso
Beacon EP2
Q8
Rembrandt EP2
Mobil
Mobilegrease XHP 222 NLG 2
Klüber Lub.
Klübersynth UH 1 14-151
Texaco
Multifak EP2
Molykote
BR2 Plus
* Not for angle gears.
