6
Any revisions must first be approved by the product designer. Version: 201909
Revision By: JST
19.
DOOR ALIGNMENT
Adjustment holes have been predrilled in the
top track. Door alignment can be achieved by
using 4mm hex key through the top track into
the top of the door hangers. Turn the key
anticlockwise to lift the door.
20.
HANDLE INSTALLATION
Assemble the handles as shown. Clear gaskets
are supplied with
the handle.
Position one on
each side
between the
glass and handle.
* The stainless steel handle assembly is optional
21.
SILL INFILL
Trim the sill infill to fit between the fixed panel
and the return panel. Apply a continuous bead
of clear silicon to each inside face of the base
channel and at each end. Ensure the ends of the
sill infill are
completely
filled and
place the infill
into the base
channel in the
location as
shown.
22.
SLIDING DOOR GUIDE BLOCK
E
nsure the guide block isn’t too tight (must
allow the glass to slide through it). Slide the
door as far back in an open position as possible.
Slip the sliding guide block under the door and
locate it in line with the end of the fixed panel
on the opening side. Apply a small bead of
silicon to the bottom and side of the block and
then place into position
–
firmly to the inside of
the glazing channel. Use a 1 or 2mm packer on
the outside of the glass to firmly press the glass
against the guide block. Tape glass and block
into place to ensure they do not move while
silicon cures.
23.
CLEAR FLEXIBLE WEDGE
2x lengths of clear flexible wedge have been
supplied. Wedge can be inserted into wall
channel, outside of glass panel. This will hold
panel in position, prior to final silicone seal.
These are to be used at installer discretion.
Wedge is
not
to be used in base channel.
Base channel and glass junction is to be
siliconed as per below.
24.
SILICON APPLICATION
Using the blue tape supplied, mask the glazing
channels and glass at the intersections as
shown. Apply clear silicon to the inside and
outside of
the base
and wall
receiver
channels.
Use a
spatula to
remove the excess silicon. Remove the masking
tape immediately after application.