5
Press the power button to activate the START timer. The hour will begin to
blink. Use the up and down buttons to select the hour. After you have
selected the hour, press the set button and the minutes will begin to blink.
Use the up and down buttons to select the minutes.
SET
When you are satisfied with the programed START time press the set button. A small
OFF
will be displayed on the left of the screen and a large
OFF
will be flashing in the center
of the screen. This indicates that the STOP timer is currently turned
OFF
. Press the
power button to activate the STOP timer. The hour will begin to blink.
Use
the up and down buttons to select the hour. After you have selected the hour, press
the set button and the minutes will begin to blink. Use the up and
down buttons to select the minutes. Once you are satisfied with your selections, wait
ten seconds and the VSC will return to time of day display, indicating that programming
was entered.
To deactivate the START/STOP timer features, repeat the programming steps and press the
power button when the START and STOP times are flashing. The time will be replaced with
a large OFF, indicating the timer is deactivated.
SET
SET
Maintenance and Inspection
Regular maintenance and inspections are recommended to determine that everything is
operating properly. If any abnormal conditions are noticed, refer to the section on
Troubleshooting and take corrective measures immediately.
Winterization
The control panel should be removed and stored inside to protect it during the winter.
Please refer the specific winterization instructions for the pump installed with the
TidalWave VSC.
Warranty
The TidalWave Variable Speed Controller carries a three-year limited warranty. This limited
warranty is extended solely to the original purchaser commencing from the date of
original purchase receipt and is void if any of the following apply:
• The VSC was used in conjunction with a magnetic induction or direct drive pump.
• The VSC was not run on a dedicated circuit.
• The cord has been cut or altered.
• The VSC has been misused or abused.
• The VSC has been disassembled in any way.
• Serial number tag has been removed.
Warranty Claims
In case of warranty claims, return the VSC to the place of purchase, accompanied by the
original receipt.
