Atlantic PAF-20SV, Руководство по эксплуатации продукта

Страница: 2 / 20

Prior to Operation and Installation
When the pump is delivered, first perform the following checks:
• Check for any damage to pump and power cable that may have occurred during
the shipment.
• Check the model number to make sure it is the product that was ordered and verify the
voltage and frequency are correct.
Caution
• DO NOT operate this product under any condition other than those for which it is
specified. Failure to observe this precaution can lead to electrical shock, electrical
leakage, fire, water leakage or other problems.
• DO NOT apply any paint over the stainless steel motor body. Reduced cooling ability will
result in overheat, overload, introduce undesirable performance reductions, periodic auto
shut-off and pump malfunction.
• The pump is a 110/120 volt 60 Hz pump, please only use with a power supply voltage
within 110-120 volt 60 Hz.
• Never place your hand or any object in or near the inlet opening while this equipment
is operating. If pump inlet is clogged, always turn off the power supply, fuse box or circuit
breaker and wait until the motor is completely stopped before attempting to remove any
clogged material.
• Please make sure that the power plug and the AC outlet receptacle is protected and away
from water or pump discharge hose to prevent accidental electric shock or short circuit.
• Always operate the pump completely submerged in water.
• Avoid dry operation, which will not only lower performance but can cause the pump to
overheat/malfunction, leading to electrical leakage, shock or premature failure.
•
CAUTION:
THIS PUMP IS TO BE USED IN A CIRCUIT PROTECTED BY A GROUND CIRCUIT INTERRUPTER.
•
CAUTION:
THIS PUMP HAS BEEN EVALUATED FOR USE IN WATER ONLY.
Introduction
Thank you for selecting the Tidal Wave PAF-20SV/PAF-25SV/PAF-40SV/PAF-75SV series
pumps. Before using this pump please take a moment to review this manual.
To avoid an accident do not use the pump in any way other than as described in this
manual. Please note the manufacturer cannot be responsible for accidents arising because
the product was not used as prescribed. After reading this manual keep it as a reference in
case questions arise during use.
2
* The chart volumes shown are in gallons per hour. Operating pumps outside of the recommended range may cause
bearing damage and premature failure.
MODEL MAX FLOW
PAF-20 ---
PAF-25 ---
PAF-40 ---
PAF-75 ---
5' 10' 15' 20' 25' 30'
2800
3900
4950
5950
5270
1950
3150
4350
4560
3570
2300
3750
2700
35'
2830
1080
1350
180
1700
1770
240
520
550