20
I
N CASE OF PROBLEM
Problems Encountered
Checks to be made
The device does not heat
- Ensure that the main circuit breakers are closed or that the overload
cut-out has not cut off the supply to the advice.
- Check the air temperature in the room : if it is too high, the heating
light
C
does not come on: the device does not heat.
- Switch your heating
OFF
and then
ON
again with the mode selection
wheel
A
:
• If the indicator light
C
flashes constantly (
continuous flashing
): the
measuring sensor is defective. Contact the manufacturer’s local After-
Sales service in order to replace it.
- Ensure that the device is not locked in the Frost-Free position.
- Check that the device is not locked onto a low temperature. If this is
the case, unlock the device and increase the temperature using the
temperature setting wheel
D
(
see page 18
).
The device heats all the
time
- Check that the device is not located in a draft or that the tempera-
ture setting has not been changed.
- There may be a fluctuation in the electricity supply. If you experience
a problem (
thermostat
locked, ...
), cut off the electricity supply to the
towel-dryer (
via the fuse or circuit breaker
) for approx. 10 minutes and
the switch it on again.
- If you encounter the same phenomenon frequently, have your power
supply checked by your local utility.
- Check that the device is not locked onto too high a temperature. If
this is the case, unlock the device and reduce the temperature using
the temperature setting wheel
D
(
see page 18
).
The
indicator
light
B
flashes.
You have locked the device and someone has tried to alter its operating
mode.
- Either unlock the device to stop the light from flashing and repro-
gramme it for the desired function,
- Or check the position to which the mode selection wheel
A
has been
set:
- If it is set to
24h Auto Heating
, set it to
ON
or
24h Auto
Drying
.
- If it is set to
ON
, set it to
24h Auto Heating
or
24h Auto
Drying
.
- If it is set to
24h Auto drying
, set it to
ON
or
24h Auto
Heating
.
The light will stop flashing when you set the mode to the position
where it had initially been locked.
