8
H
and
-
Held
r
emote
C
ontroller
o
verview
Figure 4 – Hand-held Remote Controller Overview
General Rule of Selection:
Except for the
ON/OFF
button located on the right side of the Hand-held Remote Controller, all
selections made to this device will require a gentle touch of a short period of time to achieve a response.
1.
Charging Port:
Charge Hand-held Remote Controller using supplied AC Adapter.
2.
Treatment Time
:
Set treatment time in Hours, Minutes. Hold finger on
Treatment Time
to select until menu changes
to scroll bar. Scroll the numbers up or down, positioning the times chosen in the center row. When times are positioned
correctly, select
DONE
on the screen to input your Treatment Time choice.
3.
Current Time
:
Displays current time in Hours, Minutes, Seconds. Can be reset under
SETTINGS
, however this requires a
PIN Number to do this. (See
“Setting Date and Time”
on
Page 12
)
4.
Lamp Operation Indicators
:
Lamp status glows yellow when the lamps are operating correctly. If lamp is not operating the
lamp status will be displayed grey for that lamp.
5.
Start Button:
Starts treatment cycle time.
Once selected:
a) Remaining Time changes to Countdown Time and begins counting down from 1 minute and 30 seconds to exit area
b) The words
“LEAVE AREA”
appear on the lower status bar.
c) Alarm on unit begins to sound
d) The word
“PrEP”
flashes on the Keypad during the Countdown Time, when Treatment Time begins the word
“run”
flashes and when the treatment time is completed the word
“donE”
will appear.
6.
Return Button:
Brings you back to previous screen
(Remote Overview Continued on Page 9)
Lamp operation indicators
illuminate yellow when
lamps are on
Displays current time
Hours:Minutes:Seconds
Used to define treatment
time in Hours:Minutes
Start Button
Return Button
Pause/Continue Button
Settings Button
LampControl
Treatment Time
00:00:00
00:00:00
00000:00
11:57:14
Current Time
Start
Pause
Stop
Remaining Time
Total Op Time
Connecting to SANIDYNE
Lamp Status
2
3
4
5
6
7
8
1
90%
Displays Remaining Time and
toggles to Countdown Time shown on
Cycle Time Hours:Minutes:Seconds
Begins at (1:29) minutes when pressed
Displays accumulative hours
of all treatment times
Stop or End Button
Status Bar:
• Ready
• Intruder Alert
• Session in Progress
• Session Paused
• Session Resumed
• Session Stopped
• Leave Area
• Connected to SANIDYNE
Treatment Time
Set lamp cycle time hours and minutes
Done
00
01
02
59
00
01
:
Power off
Reboot
Airplane mode
Airplane mode is OFF
Airplane mode is ON
!
Volume Button
On/Off Button
Home Button
Battery Condition
Charging Port
11
14
15
12
16
8
9
1
10
2
3
4
5
6
7
13
