Atlanta 1335MD, Техническое руководство и перечень запасных частей

Страница: 57 / 174

Technical Manual & Parts Lists
50
Explanations Flow Chart Sizing Box Springs (Page 1)
A – Changing stitch -count.
The number of stitches after the panel uncovers the photo -eye.
The higher the number the wider the corner will end.
Change the number of stitches by using the push -buttons at the front of the control-box.
B – Changing the size of the panel -seam.
The seam can be changed by moving the guide on the table -top. (Bigger/right – Smaller/Left)
If changing the seam most of the time you need to change the stitch -count too. (See A)
C – Changing the ruffle size.
The ruffle size can be changed by turning the thumb -wheel at the front of the box at the top of t
sewing -machine.
On the side of the box there is a scale. (Higher number/ Bigger ruffle)
If changing the ruffle -size most of the time you need to change the stitch -count too. (See A)
If changing the ruffle -size sometimes you need to change the stitches per ruffle. (See E)
D – Changing number of the ruffles in the corner.
The number of ruffles can be changed by changing the number on the control -box. (2nd
from r
Numbers 1 -6 are round corners.
Numbers 7 -9 are square corners, were 7 = 2 ruffles, 8 = 4 ruffles and 9 = 6 ruffles.
If changing the seam most of the time you need to change the stitch -count too. (See A)
E – Changing the stitches per ruffle.
To change the number of stitches per ruffle, change the number on the control -box. (1 st
from r
• Important: Don’t go to high with the number so the ruffle -blade is hitting the foot!!!
F – Changing the panel -tension.
Changing the panel-tension can be done by changing the air -pressure with the regulator.
The air-regulator is located under the table at the frame.
The tension “Finger” is located in front of the sewing -machine on the table -top.
Too much tension will give a wrinkled border. Not enough tension will give a wrinkled panel.