Atlanta Attachment Company 1335AY, Техническое руководство и перечень запасных частей

Страница: 19 / 116

Technical Manual & Parts Lists
12
Light Tower Functions
The purpose of the Light Tower is to provide a visual indication of the current status of the
machine that can be seen at a considerable distance from the machine. Definitions for the different light
states currently available on the 1335 are included below.
Light Status Definition
Green Steady
Machine is making a panel.
Green Flashing
Machine is sewing the last side of the panel and will finish soon.
Yellow Steady
Machine is on but idling between panels.
Yellow Flashing
Machine is stopped in the middle of a panel and needs operator
attention before continuing. Possibly the machine has stopped
because of an error, thread break, etc. If the operator cannot recover,
the mechanic must be called.
Red
Available for future use, not currently utilized
Basic Machine Operation
Loading the Gusset and Flange Material into the Flanger Module
Load the flange material onto the roll holder between the accumulator and the flanger module.
The material should unroll from the bottom right of the roll. Feed the material up through the tension
plates, through the flange guide, and under the presser foot and puller. Check the alignment of the
material to the needles and adjust the roll position and guides as necessary to keep the material straight.
Use the Flanger manual Foot Lift pedal to raise the foot and puller.
Load the roll of gusset material onto the roll holder between the two discs so that when the
material is fed toward the accumulator the good side of the fabric is up. Be sure the drag tension tape is
draped over the top of the roll and the discs are loose against the roll core. Feed the gusset straight
between the movable and stationary rollers toward the guide rods. Feed it into and through the Flange
Guide and under the presser foot and puller roller. Use the Flanger manual Foot Lift pedal to raise the
foot and puller. Refer to the diagram on page 115 for component identification and location.
Using the Flanger SEW pedal, sew about 10 feet of material through the flanger. Check the stitch
margin and adjust the guides as necessary. There must be enough material to load the Ruffler folder and
leave a loop in the flanger long enough to cover the loop control eye
From
the
library
of:
Diamond
Needle
Corp