ATL IB2S-A, Руководство пользователя

Страница: 13 / 46

Connections
!
!
Caution
To avoid potential damage, please ensure that the signal source is turned off before
connecting or disconnecting your active loudspeakers.
Connections
The rear panel of the IB2S-Active Series carries various connectors for audio, control
and mains power.
Audio
The electronically-balanced analogue audio input and the AES3 digital input accept
3-pin male XLR connectors, wired with
Pin-1 screen (ground), Pin-2 signal positive
(hot), and Pin-3 signal negative (cold). If the monitor is to be used with an unbalanced
analogue signal source pins 1 and 3 of the input XLR should be connected together
inside the male XLR plug. Thru connections are provided for signal distribution.
Power
A single IEC (C14) mains socket is provided with an integral fuse-holder, voltage
selector (115/230VAC) and power switch. Only change fuses with the power cord
removed completely from the loudspeaker. A remote powering facility is provided via
the ‘Trigger In’ terminals which accept a 4 to12V AC or DC voltage to enable remote
switch on from an external device. The Trigger Thru terminals can be used to extend
the control signal to another speaker in the system.
Remote Control
The ‘Remote In’ RJ45 socket accepts the connection from the remote control unit,
while the Thru socket is used to distribute the control signal to the next speaker in the
system.
Please Note that the final loudspeaker in the chain must have the loopback
connector fitted to the RJ45 Remote Thru socket.
Note: This unit must be earthed.