ATIKA ASP 8-1050 -, Руководство по эксплуатации

Страница: 22 / 96

21
ing levers (9) down simultaneously –
w
lits the
5.
ng blade
L
ver, then the split-
Preparations:
ns
(pa d
s of wood smaller than approx. 500 mm and larger
ant te by shortening
2.
so that
this
3.
ct the
4.
5. the
locking screw
using a socket
(18) upwards until 3. Hold the log tight with the clamping claws (8).
4. Press both operat
Fig. 2.
Î
The split-
ting blade (2)
falls do n
and sp
log.
Release the
two operating
levers, the
splitti
returns to its
initial position.
9
If you only release one operating le
ting blade remains where it is.
Special instructions for splitting logs:
ƒ
The logs to be split should be cut to the maximum dimensio
hat the logs are cut straight an ge 19). Ensure also t
square.
ƒ
Adjusting the stroke height
For piece
qu
ities, you can increase the working ra
the return path of the splitting blade.
1.
Place the log
on the splitting
table and
press the two
operating lev-
ers (8) to
bring the split-
ting blade (2)
down to
approx. 2 cm
above the log.
Fig. 3
Release one
operating
lever
the blade
stays in
position. Fig. 4
Switch the
machine off
and discon-
ne
power.
Release the
second oper-
ating lever.
Unscrew
wrench. Guide the lift adjustment rod
the lift adjustment rod is stopped by the spring. Retighten
the locking screw. Fig. 5
justing the height of the ta e Ad bl
upper position of table for logs up to 590 mm
middle table position for logs up to 780 mm
lower position of table for logs up to 1040 mm
middle table position
1.
Release the locking hooks. (10)
. Pull the table out.
comes close to the log
t with the locking hooks.
2
3.
Use the table in a position that
length and secure i
5
Locking screw
6
4
3
7
2
8
8