12
O&M Manual
– Rev-C
Part 4 – Electrical Installation
4.1
General
The sensor cable can be quickly connected to the Q45 terminal strip by matching
the wire colors on the cable conductors.
4.2
Cable Connection
The sensor cable should be routed into the enclosure through the right hand cord
grip on the bottom of the enclosure. Make sure the cord-grips are snugly
tightened after electrical connections have been made to prevent moisture
incursion. When stripping cables, leave adequate length for connections in the
transmitter enclosure, as shown below.
Figure 4 - Sensor Cable Preparation
