Athena UPS APA-103T, Руководство пользователя

Страница: 8 / 34

7
Buttons Description
1. LCD Display
When AC plugs in (UPS is not switched on.) this LCD
display light will be on. UPS operation information can be
seen including UPS status, input/output voltage,
input/output frequency, battery voltage, battery capacity,
load capacity, temperature, and event logs. UPS output
voltage and frequency can be set from it here, too.
2. Up Key
Press to select upward.
3. Down Key
Press to select downward.
4. Enter Key
Press to enter the setting page and save the settings.
Switch ON
Press both Key (3) and Key (4)
simultaneously for 3 seconds
until UPS beeps for twice.
Switch Off
Press both Key (2) and Key (4)
Simutaneouly for 3 secnonds
until UPS beeps for twice.
Mute
When UPS is on and is on DC mode, UPS
will beep every 4 seconds. Press both
Key (2) and Key (3) simultaneously for 3
seconds to turn off UPS buzzer.
NOTE:UPS beeper will be enabled automatically in server
cases such as overload, overheat, and battery low...etc.
LED indication:
5. Fault
LED
Red LED indicates that the UPS is in a fault condition.
There are problems needed to be solved. Such as
inverter abnormal or over-temperature or DC_BUS fault.
6. Warning
LED
Yellow LED indicates that the UPS is in a status which the
user should be aware but not worried yet. Such as UPS
overload or UPS is on battery back-up.
7. Normal
LED
Green LED indicates that the UPS is operating normally.