6
5
3.1.3 Put the charge point onto the bracket, and fix it with the 2 screws at the bottom of
the charge point. The installation is done.
3.1.4 Crimp the below shown insulated ferrule or ring terminals on the end of the AC input
wires. Connect the wires into the terminal block of the charge point as below. Check the
wiring and then close the RCD in the side window. Close the side window with the cover,
then the wring is done.
3.2 Mount on a pole
3.2.1 Open the packaging of the pole, take out the pole and mounting accessories.
3.2.2 The pole must be installed on a hard surface, concrete surface is recommended, it
can also be mounted on a solid ground. Drill hols according to the requirements marked
on the illustration for fixing expansion bolts.
3.2.3 Fix the pole onto the holes with expansion bolts. The input cables shall go into the
pole from the bottom middle area and come out of it from the area below the cable
hooker.