ATEN IC485SN, Руководство пользователя

Страница: 14 / 19

- 14 -
Installation
1. Set each IC-485SN's configuration switches according to the
information provided in the Switch Configuration and
Operating Modes sections.
2. Plug the IC-485SN's DB-25 female connector into the
computer's RS-232C port.
3. Connect the IC-485SN units to each other:

Use two or four wire twisted pair cable in a reverse or
straight through configuration according to the information
provided in the Switch Configuration and Operating Modes
sections.

You may use either the RJ-11 telephone socket, or wire
directly to the Terminal Block. (See the Terminal Block Pin
Assignments table for pin assigment details.) If you are
daisy chaining units, you will need to use either a two-to-
one RJ-11 adapter, or a combination of the Terminal Block
and the RJ-11 socket.
Note: 1. When tightening the terminal connector screws it is
recommended to use a Phillips PH1 Screwdriver.
2. Over-tightening the terminal connector screws may
result in damage to your IC-485SN and difficulty
loosening the screws.
4. Power on the computers. The units are now ready for
operation.