CS1768 User Manual
10
Stacking and Rack Mounting
The CS1768 can be stacked on the desktop or rack mounted at the front or rear
of the rack. The following sections take you through the procedures for each
method.
Note:
1. Allow at least 5.1 cm on each side for adequate ventilation and
12.7 cm at the rear for power cord and cable clearance.
2. The standard rack mounting kit does not include screws or cage nuts.
If you need additional screws or cage nuts, contact your rack dealer.
Stacking
The CS1768 can be placed on any level surface that can safely support its
weight and the weight of the attached cables. Make sure that the surface is
clean and free of any materials that can block the exhaust vents or otherwise
interfere with normal operation of the switch.
To place the CS1768, or to stack units if you are cascading them, remove the
backing material from the bottom of the rubber feet that came with this
package, and stick them onto the bottom panel at the corners, as shown in the
diagram, below:
Содержание CS1768
