ATEN CE600, Руководство пользователя

Страница: 21 / 38

Chapter 2. Hardware Setup
13
Setting Up
Setting up the CE600 / CE602 DVI KVM Extender system is simply a matter
of plugging in the cables. Make sure that all the equipment to be connected up
is powered Off. Refer to the installation diagram on the following page and do
the following:
1. Plug the appropriate connectors on the DVI KVM cable supplied with this
unit into their ports on the front of the Local Unit (CE600L / CE602L).
2. Plug the connectors on the other end of the DVI KVM cable into the
appropriate ports on the local computer. Each connector is marked with an
appropriate icon to indicate which it is.
Note: If you are combining the CE600 / CE602 with a KVM switch, the
other end of the DVI KVM cable plugs into the appropriate ports on
the KVM switch.
3. For control of serial devices, connect the RS-232 serial port on the local
unit to a serial port on the local computer.
4. Plug either end of the Cat 5e cable into the CE600L / CE602L's Sub / Main
ports. Plug the other end of the Cat 5e cable into the Sub / Main ports of
the Remote Unit (CE600R / CE602R).
Note: For DVI Dual Link or HDCP-supported installations (CE602 only),
both Main and Sub ports can be used. A second Cat 5e cable is
needed for HDCP, RS-232, microphone and dual link signals. The
length of the two Cat 5e cables must be the same. For Single Link
DVI installations, only one cable (Main-to-Main) is required.
5. Plug one of the power adapters (supplied with this package) into an AC
source; plug the adapter's power cable into the CE600L / CE602L's Power
Jack.
6. Plug the cables from the remote console devices (mouse, keyboard,
monitor, speakers, microphone), into their ports on the Console side of the
CE600R / CE602R.
7. Plug the second power adapter (supplied with this package) into an AC
source; plug the adapter's power cable into the CE600R / CE602R's Power
Jack.