Software Setup
If your motherboard USB header pin layout matches one of
the examples above, you will not need to reassign the wire
pins on the internal USB cable.
If your motherboard USB header pin layout does not match
the examples above, please take following steps to reassign
the wire pins on the internal USB cable.
(1) Determine the wires that you need to remove from the pin
connectors first by referring to your motherboard USB
header pin layout.
(2) Using a needle or push pin to flip up the tiny plastic tab
and pull the wire out from the connector. Please take
caution on this step as excessive force on flipping the tab
may cause the tab to break.
(3) Repeat above steps for each wire that requires changing.
(4) Insert the wire pin back into the correct slot and press the
tiny plastic tab down will hold the wire in its position.
The diagram below shall give you an idea of how it is done.
Windows ME and Windows XP or later
Software Setup for PRO II under operating systems, like Windows
ME and Windows XP, is very simple . No software driver is required.
Here are the few steps:
1. Once you plug in the two external USB cables (as described in
Hardware Setup), your computer shall immediately recognize
the PRO II device and install all drivers automatically.
2. You shall see a small icon appear on the lower right hand corner
of your desktop. (as shown below)
Windows 98, Windows 98 SE and Windows 2000
For Windows 2000
Prior to installation of PRO II reader/writer, please take following
steps to install device driver first, then proceed with the necessary
cable connections (as described in Hardware Setup), and reboot
the computer.
A software setup file can be downloaded from our web site:
http://www.atechflash.com/ drivers/pro2setup.exe.
E
xa
m
ple
B
1. USB Power (or VCC or +5V) 10. GND
3. P-
8. GND
5. P+
6. P+
7. GND
4. P-
9. (Empty pin)
2. USB Power (or VCC or +5V)
