VFS-DH Page 3 of 4
4.
Attach your Display to the Quickshift Donut
4.1
Hook the top of the VESA plate
onto the Quickshift Mount.
4.2
Press and hold the two buttons
on the Quicksheft Mount. Gently push
bottom of VESA Plate into Quickshift
Mount. Release Buttons to lock in place.
4.3
(Optional) Insert the Security
Screw, and tighten using a Phillips-head
Screwdriver.
5.
Adjust horizontal position of the monitor
5.1
Open the lever to loosen
the Quickshift Donut.
5.2
Slide the Quickshift
Donut to desired position.
5.3
If necessary, adjust the
tension between the Donut
and the Pole using the 5mm
Allen Key supplied.
5.4
Close the lever to lock the
Quickshift Donut in place.
HOOK
Back of
Display
OPEN
LOOSEN
TIGHTEN
SLIDE
CLOSE
Release
Button
PUSH
TIGHTEN
Security
Screw
6.
Adjust the ball joint tension
7.
Cable Management
6.1
If the monitors are not holding position or are
stiff to move, adjust the tension plate by tightening
or loosening the three screws.
+
-
Note:
Adjust 3
screws
evenly
in
small increments
Note:
Support the monitor while making adjustments.
3mm
Allen Key
7.1
Connect cables to your monitors. Then route them
down to the table by inserting them into the cable slots
in the Crossbar and Upright Pole. Use either the Cable
Balls or Cable Cilps to secure them in place as shown.
Leave slack
in cables
Cable
Balls (x6)
Cable
Clips
Leave slack
in cables
Cable
Balls (x6)
Cable
Clips
Note
Ensure enough slack is left in cables
to allow for movement. When the slot in
each pole cannot be used, use the supplied
Cable Clips to secure the display cables.
