AWM-2-LTH75-H Page 6 of 6
3.
Mount monitor onto Channel Clamp
3.1
Push tilt head onto the shaft at the
end of the channel clamp, grub screw
must be backed off at this time
3.3
Tighten the joint screw with 4mm
allen key to secure the tilt head and
monitor in place.
NOTE:
Check the head pan adjustment
is smooth after tightening.
3.2
Ensure tilt head is fully pushed
onto shaft.
NOTE:
Ensure plastic sleeve is on shaft
before fitting tilt head.
Re-attach
Tighten
Remove
NOTE:
In most cases,
monitor will balance in a
level position with factory
settings. If it droops to one
side follow these steps to
adjust the rotation tension.
5.
(Optional) Adjust rotation tension
5.1
Remove VESA head
from monitor.
5.3
Re-attach VESA head to
monitor as per
Step 1.
5.2
Tighten the two screws on
the front of the VESA plate
using 4mm allen key.
Loosen
Tighten
4.1
Use the knob to tighten and loosen the
tilt tension to suit your monitor weight.
NOTE:
Always support the
monitor whilst adjusting
to prevent it from falling
forward sharply.
IMPORTANT
If extra tilt tension is required for
your monitor, use 4mm allen key
to tighten second tilt screw.
Loosen
Tighten
4.
Adjust tilt tension
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©
20220321
