AWM-BT Page 3 of 3
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©
20221124
4. Fine adjustment
3. Attach display
3.1
Set VESA plate to
open position.
WARNING:
Use two people to
install display
3.2
Lift display until VESA
plate is above the height of
the bracket.
3.3
With post centered slowly
lower display until bar on VESA
plate sits in saddle in bracket.
3.4
Set VESA plate
to
closed
position by
sliding clips on both
sides inwards.
3.5
Adjust display tilt
angle by gripping edges
of screen and rolling up or
down to desired position.
3.6
Tighten tilt knobs
to set display angle.
4.1
To correct horizontal angle
of d/- 3°:
Turn a single fine adjustment
knob to adjust angle of display.
4.2
To close small gap between
di/-6mm (1/4”):
Turn both fine adjustment
knobs - alternating sides a few
rotations at a time.
OPEN
WARNING:
Do not loosen
hand knob once
display mounted�
OPEN
CLOSED
Clockwise = More friction
Anti-clockwise = Less friction
OPTIONAL ADJUSTMENT
- TILT FRICTION
4mm Hex key can be used
to reduce tilt friction (for
light screen) or increase tilt
friction (for heavy screen).
F
TILT
KNOBS
CLOSED
Clockwise = Higher
Anti-clockwise = Lower
FINE HEIGHT ADJUST
FINE ADJUSTMENT
KNOBS
NOTE:
Ensure slide clips in
CLOSED
position
