AD-WF-5060 Page 2 of 2
NOTE:
• Choice and supply of appropriate wall plate fasteners is the
responsibility of the installer.
• Consult a preferred fastener supplier or a structural engineer to
select fasteners which are most appropriate for the weight of
the display and wall construction method.
• Wall plate
must
be level. Verify using a quality spirit level tool
or the included spirit level
G
.
• On a Stud Wall or Drywall use a good quality Stud Finder to
position mounting fasteners in the centre of studs.
• On a Masonry Wall avoid positioning Wall Plate mounting
fasteners in a mortar join.
J
G
Slot Dimension
Ø8 x 40mm
*Fasteners shown are not included
NOTE:
• Always use multi-washers
D
.
• Use the shortest combination of spacers (if necessary) ensuring the
display is not loose and screws are not forced too deep into the display.
B (M6X30) /
C (M8X30)
B (M6X30) /
C (M8X30)
D
E
D
F
F
E
D
D
F
F
E
E
D
F
D
B (M6X30) /
C (M8X30)
C (M8X50)
C (M8X50)
C (M8X50)
A (M4x14) /
B (M6X14)
D
“CLICK”
“CLICK”
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©
20210813
1
2
3
1. Mount the Wall Plate to the Wall
3. Hook the Display onto the Wall Plate
4. Check Security and Conceal Straps
3.1.
Angle the display and hook the Display Brackets over the
top of the Wall Plate. This should be completed by two
people.
3.2.
The silver locking tabs on the Display Brackets will make
a “click” sound to confirm a secure installation. You may
need to gently apply pressure to the lower half of the
display if this does not happen automatically.
4.1.
Gently pull the display forwards from bottom of the
display to ensure the the locking tabs have engaged with
the wall plate and the display cannot be tilted upwards.
4.2.
Conceal straps behind the display using the magnets at
the end of each strap to prevent accidental unlock and
dismount of the display.
NOTE:
Ensure the silver locking
tabs are pushed in prior
to mounting the display.
NOTE:
To unlock display from the Wall Plate for display removal
- retrieve the straps from their concealed position and pull
each strap down once briefly until a “click” is heard.
2. Attach the Display Brackets to the Display
