ATD Tools ATD-WB, Инструкция по установке и эксплуатации

Страница: 5 / 23

6. INSTALLATION AND COMMISSIONING
A Ō er unpacking the various parts of the wheel balancer, ensure they are intact and check for any anomalies, then assemble
the parts.
6.1 Electrical Connec Ɵ on
The standard version of the machine must be connected to a 110V, 60HZ, SINGLE PHASE power supply.
To complete the electrical connec Ɵ on, install the plug provided to the machines power supply cable.
ALL THE OPERATIONS REQUIRED TO MAKE THE ELECTRICAL CONNECTION AND ANY
WORK (HOWEVER SLIGHT) ON THE ELECTRICAL PARTS MUST BE CARRIED OUT BY
QUALIFIED PERSONNEL.
Electrical cables must be sized according to the electrical power used by the machine. The user must:
- Check that the supply voltage corresponds to the voltage indicated on the nameplate of the machine.
- Check the condi Ɵ on of wires and the presence of the ground conductor.
- Check that the machine is connected to its own circuit, ĮƩ ed with a 30A circuit breaker
- Connect the power supply cable to the plug with the utmost care, in accordance with applicable regula Ɵ ons.
WHEN THE MACHINE IS OFF AND UNUSED FOR LONG PERIODS, IT IS NECESSARY TO
DISCONNECT THE POWER SUPPLY PLUG TO PREVENT USE BY UNAUTHORIZED
PERSONNEL.
IN CASE OF OPERATIONS ON LINES, MOTOR INTERNAL PARTS OR ANY ELECTRIC
EQUIPMENT, IT IS NECESSARY TO DISCONNECT FROM MAIN POWER FIRST.
DO NOT REMOVE OR DAMAGE WARNING, INSTRUCTION AND CAUTION STICKERS
ILLEGIBLE. REMOVED OR DAMAGED STICKERS CAN BE OBTAINED THROUGH YOUR
DISTRIBUTOR.
ANY DAMAGE RESULTING FROM FAILURE TO COMPLY WITH THE ABOVE INSTRUCTIONS
WILL NOT BE CHARGED TO THE MANUFACTURER AND MAY INVALIDATE THE WARRANTY.
IF THE CONNECTION TO THE ELECTRICAL LINE OCCURS DIRECTLY THROUGH THE
PANEL, WITHOUT THE USE OF ANY PLUG, IT IS NECESSARY TO SET UP A KEY SWITCH TO
RESTRICT THE MACHINE USE EXCLUSIVELY TO QUALIFIED PERSONNEL.
ELECTRICAL
5