WARNING:
Always remove the power cord from the electric outlet when making adjustments, changing parts,
cleaning or working on the light.
WARNING:
Care should be taken to arrange the cord so it will not be stepped on, tripped over, or otherwise
subjected to damage or stress.
WARNING:
Never a
Ʃ
empt to plug in or operate light with defec
Ɵ
ve or damaged wires, power cord or
power cord plug. Have any defec
Ɵ
ve or damaged parts replaced immediately by quali
Į
ed personnel.
WARNING:
Avoid body contact with electrically grounded surfaces. There is an increased risk of electric shock if
your body is grounded.
WARNING:
If the work area is not equipped with a permanently installed Ground Fault Circuit Interrupter outlet
(GFCI), use a plug-in GFCI between the power light or extension cord and the power receptacle.
WARNING:
If an extension cord is necessary, use only ‘Listed’ extension cords. If used outdoors, they must be
marked “For Outdoor Use”. Those cords having a 3-prong grounding type plugs and ma
Ɵ
ng receptacles are to be used
with grounded lights.
WARNING:
Use of improper size or gauge of extension cord may cause unsafe or ine
ĸ
cient opera
Ɵ
on of your
light, or cause damage to your light. Be sure your extension cord is rated to allow su
ĸ
cient current
Ň
ow to the light. If
in doubt, always use a larger gauge cord. Be sure to check the voltage requirements of the light to your incoming power
source.
NOTE
:
The table below shows the correct size to use according to cord length and the amperage draw of the light
When in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.
Minimum Gauge for Extension Cords (AWG = American Wire Gauge).
(when using 120 volts only)
Ampere Ra
Ɵ
ng
Total Length of Cord in Feet (meters)
More Than
Not More Than
25' (7.6m)
50' (15m)
100' (30.4m)
150' (45.7m)
0 6 18
16
16 14
6 10 18
16 14 12
10 12 16
16 14 12
12 16 14
12
Not Recommended
