General Safety Warnings:
WARNING:
The instruc
Ɵ
ons and warnings contained in this manual should be read and understood before using
or opera
Ɵ
ng this light. Do not allow anyone to use or operate this light un
Ɵ
l they have read this manual and have
developed a thorough understanding of how this light works. Failure to observe any of the following instruc
Ɵ
ons could
result in severe personal injury to tool user and bystanders, or cause damage to the tool and property. Keep this manual
for future reference.
Note:
The warnings and cau
Ɵ
ons discussed in this instruc
Ɵ
on manual cannot cover all possible condi
Ɵ
ons and
situa
Ɵ
ons that may occur. It must be understood by the operator that common sense and cau
Ɵ
on are factors which
cannot be built into this product, but must be supplied by the operator.
WARNING:
Always keep your work area clean, unclu
Ʃ
ered, and well lit. Clu
Ʃ
ered or dark areas invite accidents
and injuries. DO NOT work on
Ň
oor surfaces that are slippery.
Electrical Safety Warnings:
WARNING:
Read all safety warnings and instruc
Ɵ
ons. Failure to follow all warnings and instruc
Ɵ
ons may result
in electric shock,
Į
re and/or serious injury or death.
WARNING:
Before connec
Ɵ
ng a light to a power supply, always check to ensure the power supply corresponds to
the voltage requirements of the light. A power supply with a voltage greater than that speci
Į
ed for the light
can result in
serious injury to the user, as well as damage to the light. Using a power supply with a voltage less than the recommended
ra
Ɵ
ng is harmful to the light. If in doubt, do not plug in the light.
WARNING:
Grounded lights must be plugged into an outlet properly installed and grounded in accordance with
all codes and ordinances. This light is equipped with a 3-prong plug and a 3-wire grounding system. Never remove the
grounding prong or modify the plug in any way. Do not use any adapter plugs. Check with a quali
Į
ed electrician if you
are in doubt as to whether the outlet is properly grounded.
NOTE
:
Double insulated lights are equipped with a polarized plug (one blade is wider than the other). This plug
will
Į
t in a polarized outlet only one way. If the plug does not
Į
t fully in the outlet, reverse the plug. If it s
Ɵ
ll doesn’t
Į
t,
contact a quali
Į
ed electrician to install a polarized outlet. Do not change the plug in any way.
WARNING:
To reduce the risk of electric shock, DO NOT use in damp condi
Ɵ
ons, on wet surfaces, or expose to
rain. Do not plug in this light or operate it with wet hands or while standing in water.
WARNING:
Never use the cord for carrying, pulling or unplugging the light. Grasp plug and pull to disconnect
from outlet. Keep cord away from heat, oil, sharp edges or moving parts.
Replace damaged cords immediately.
