ON/OFF trigger switch (Fig. 4)
To start the cut-off saw, squeeze the trigger
switch (1). To stop the cut-off saw, release the
trigger switch.
Reset switch (Fig. 4)
If the cut-off saw does not start when the trigger
switch is depressed, press the reset switch (2).
Squeeze the trigger switch to start.
Swivelling vise clamp assembly with
quick-release latch (Fig. 5)
Always secure the workpiece between the angle
plate and the vise pressure plate when cutting.
1. Place the workpiece between the angle
plate (1) and the vise pressure plate (2).
2. Push the vise screw (3) toward the angle
plate and turn the vise wheel (4) clockwise to
secure. To release, turn the wheel counter-
clockwise two turns, raise the quick-release
latch (5) and pull the vise screw towards you.
Angle plate (Fig. 6 and 7)
The angle plate can be moved forward,
backward, or rotated for angle cutting.
1. To set a cutting angle, loosen the two bolts (1)
and rotate the angle plate (3) up to 45˚ right
or 45˚ left. Align the index (2) with the red line
on the saw table. Retighten the bolts.
2. Always centre the workpiece over the table
slot-web to maximize cutting depths. Move the
vise pressure plate (4) toward the angle
plate (3). Tighten angle plate bolts (2) and
vise pressure plate (4).
3. To move the angle plate (3), remove the two
bolts (1) and washers. Move the angle plate to
the desired position and align the angle plate
with the threaded holes on the saw base.
Insert the two bolts and washers and tighten
to secure the angle plate to the table.
VII. Operation
10
Fig. 4
Fig. 5
Fig. 6
Fig. 7
1
2
1
2
5
3
4
2
1
3
3
4
