-4-
ATC Electrical & Mechanical,
ATC House, Broomhill Drive, Tallaght, D24 EF99, Ireland
IE: 01 4678301, UK:0203 564 9164, Email [email protected]
GENERAL WIRING DIAGRAM
HEATER MOUNTING INSTRUCTIONS
45
45
14
66
Concrete or Brick
Timber or Plaster
Hang the heater on the
Bracket
The water heater should be installed close to a water drainpipe so that excess water from
the safety relief valve can drain away without harm; this drain pipe should always be kept
free of obstruction.
Fix the mounting bracket supplied with the heater to the wall; see below for dimensions
of the holes required; always use screws that are suitable for the wall material and the
weight of the heater otherwise the heater may pull the bracket off the wall.
Hang the water heater on the bracket.
Tug downwards on the heater to ensure that both “fingers “of the bracket are seated in
the mounting slots.
The heater can also be stood on its base using the rubber feet provided for this purpose.
Attach the four adhesive feet to the base of the heater before plumbing.
Confirm water piping orientation before wall mounting.
Note: If using the rubber feet, it is not neces-
sary to use the wall bracket also.
Should the installer wish to use the bracket as
an additional fixing method, confirm location
of bracket with feet attached to heater prior to
installation.